I am attempting to model a case where a Heat Recovery Unit has been added to the building, so I want to create two different air loops for the same zones in DB. One loop is for the Energy Recovery Ventilation System. The other is for a standard Water-to-Air Heat Pump HVAC system.
So far I have not been able to connect to air loops to one zone group, looking in the forums i found that in EnergyPlus "a zone is added to the AirLoopHVAC based system through the "Zone Air Inlet Node" (of which there can be many)"
(https://unmethours.com/question/9443/ho ... dio-model/). So I am wondering if it is possible to do this in DesignBuilder.
Thanks in Advance,
Help and discussion on using the Detailed HVAC option
Moderator: DesignBuilder Support
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests