Infiltration between zones

Help on setting up the building geometry, including importing from BIM

Moderator: DesignBuilder Support

simonegabbiani
Posts: 1

Infiltration between zones

Postby simonegabbiani » Sat May 19, 2018 4:12 pm

Hi, I have some problems to set an infiltration rate between two zones separated by an horizontal partition, a slab. I' m talking about internal infiltrations, not with external air.
I found a way to set the fessuration rate of the slab from the Costruction tab and editing the Template. There is an easier way to set infiltrations between internal zones?

Thank you

Return to “Geometric Modelling”

Who is online

Users browsing this forum: No registered users and 2 guests